Instruction manual

SCORER USER’S MANUAL
8
USING PERFECTBACK™ LF
STRIPS (continued)
VI
Assembling your Document
1. With your cover and the Centering Guide in their
last positions, slide your cover over so its right
edge (A) stops against step 3 (figure 13). Push
the lever to the right to hold down your cover.
2. Peel off the thin release paper from the front
of
your bound book block (figure 14).
3. Fold your cover up to the left so it rests against
the side of the Die Holder (figure 15). Run your
finger back and forth at the bottom at the spine
area of the cover so it makes a sharp fold at the
bottom.
4. Lay the book block, front facing up, on the right
side of the Platform with its bottom edge resting
against the Guide Rail (figure 16). It is OK if part
of it rests on top of the Centering Guide. Push
the spine of the book block against the spine
portion of your cover that is folded up.
5. With the book spine pushed fully and firmly to
the left, fold the cover over your book block
(figure 17). Starting at the middle, rub down
back and forth to secure the cover to the
adhesive.
6. Release the clamp by bringing the Lever to the
upright position. Remove the partially bound
book and turn over. On the back side remove
the remaining release paper (figure 18).
7. Now fold the cover tightly all the way over the
top of the book block. Rub back and forth on
the top near the spine (figure 19) to secure the
adhesive beneath the cover.
8. Trim the book ends as desired.
Handheld document assembly
This is an alternate method of assembly which some
people prefer. It does not require an assist from the
machine. Refer to page 11 for a description.
F I G U R E 18
F I G U R E 14
F I G U R E 13
F I G U R E 15
F I G U R E 16
F I G U R E 17
F I G U R E 19