Instruction manual

SCORER USER’S MANUAL
3
FIRST TIME SETUP II
B. Setting Up
Place the machine on a flat, stable work surface. Cut the
two shipping bands. Remove the cardboard Centering
Guide retainer and the dark cover that is under the clear
bar. Your Scorer is now ready to use!
A. What’s Included Inside the Box
Scoring Machine with Die Holder
Accessory Pack, which contains:
Starter kit of:
5 narrow Perfectback™ LF™(layflat) strips
3 preprinted wraparound covers
1 Demonstration Cover
2 extra die holder pins
User’s manual
If any of the preceding items are damaged or missing,
contact your dealer immediately.
C. Changing Die Holders
Two metal pins attach the front and rear of the
Die Holder to the machine (figure 2). To remove
the Die Holder, push these pins out sideways with
a pointed object such as a small screwdriver.
The Die Holder may now be lifted off — it is best
removed by keeping it level while lifting. Because of
the exacting fit of the parts, if the Die Holder gets
slightly angled it may stick while being lifted. Should
that happen, gently push it down and start again.
To install a different Die Holder make sure the fully
rounded end of the clear bar faces the front of the
machine. Maneuver the bar so it slides onto the two
vertical shafts sticking up from the platform of the
machine. Carefully lower it all the way down. Reinsert
the front and rear pins from the side to secure the bar.
F I G U R E 2