Product Manual

8
Before Each Use
1. Inspect power cord for fraying, cuts or damage; do not use if damaged.
2. Verify that paper bag is installed.
3.Conrmthatltersareinplaceandnotobstructed.
After Each Use
1. Unplug cord from wall by pulling on the plug, not the cord.
2. Lay plug on the ground.
3. Start at the machine and loosely wrap (loop) power cord.
4.Hangcordoncordhookonharnessframe(gure1).
Periodic Maintenance
1. Inspect all electrical connections.
2. Check power cord for any breaks, cuts, separation or fraying. Replace if damage is visible.
3. Make certain the grounding plug is intact.
If the vacuum will not turn on:
1.Makesurethepowercordisrmlyconnectedtotheunitandisingoodcondition.
2.Checktomakesurethepowercordisrmlyseatedinthewalloutlet.
3. Check to see if the building circuit breaker is tripped. If the circuit is overloaded, move the unit to another circuit.
Thebackpackhasbeenttedwithathermaloverloadswitchtoprotectthemotoragainstdamageshouldtheairowbe
blocked for extended periods. This may occur if the paper bag is overfull, the micro cloth bag is clogged, or if the vacuum
hose or exhaust is blocked. The vacuum motor will stop before it can get too hot. If this occurs, empty and thoroughly
cleanthevacuumbagandlters,orfreeanyblockageandensurethatadequateairowisrestored.Ifthemotorshuts
down, turn off power switch, unplug the backpack and allow to cool. When you plug it in, after cooling, the motor will
operate when the power switch is enabled.
trouble ShootIng
MaIntenance
Routine maintenance can signicantly increase the life of your backpack vacuum. The applications and amount
of use varies, so the recommendations listed below are for average-to-high volume use. Constant operation may
require additional maintenance.
Powr-Flite.com
1.