Product Manual

4
Fig 5
Fig 6
Switch
Trigger
Safety
Switch
Fig 4
HOW TO OPERATE THE MACHINE
• Plug the machine in as directed and lower the handle to the desired
operating height and leave the cam lever unlocked. Push the safety
switch forward (Fig 4) and squeeze the switch triggers beneath the
handle grips. This activates the motor and starts the block, brush
or attachment in operation. Each time you release the triggers
the safety switch will reset. You will need to follow the direction
above to restart the machine. CAUTION: When leaving the machine
unattended, disconnect the wall plug and return the handle to the
“locked” upright position to prevent accidental starting.
• Push the machine forward in a straight line, at a slow walking speed.
Overlap each pass by about 1 inch (25 mm).
AFTER USING THE MACHINE
• Upon completion, dust mop with treated mop to pick up all
burnishing residue.
• The condition of the floor pad has direct affect on the performance
of your burnisher. When the pad becomes dirty, turn it over and
use the other side. When finished, wash the pad out and allow it to
dry completely before using again.
• Unplug the power cord and wrap it under the cord hook and over
the right handle grip.
• Tip the machine back and remove floor pad.
• Wipe off the machine housing and the cord. This will prevent build-
up of unnecessary residue.
TRANSPORTING
Use the rear wheels for transporting the NM1600, NM2000 and
NM2000DC. This will insure that the operating wheels remain
clean and smooth for use on clean floor surfaces. (Fig 5).
MAINTENANCE
• Once a month, remove the motor cover of the unplugged NM1600,
NM2000 and NM2000DC by removing the motor cover screws.
• Vacuum out any dust or debris which has accumulated in the
motor. (Fig 6)
• Replace motor cover and replace the motor cover screws.
• Check and maintain tightness of all fasteners.
WARNING: do not over-tighten switch housing screws.
• Keep the burnisher clean, especially at the handle tube and collar
so the handle tube will move freely through the collar.
• Inspect cord and plug for cuts, gashes or loose prongs; replace as
needed.
• For the NM2000DC dust-control burnisher, periodic cleaning and
filter/filter tube inspection for clogs, debris, and/or obstructions is
recommended. If the filter is no longer serviceable, contact Powr-
Flite for a replacement filter, P/N 19069.
• The length of the carbon brushes should be inspected annually. If
they are no longer extended past the holder window, they should
be replaced.
• Replacement of carbon brushes should be done only by a qualified
service technician.
• Disassembly of this motor voids the warranty.
• Improper disassembly and assembly of this motor can
permanently damage the armature.