OPERATOR’S MANUAL Powr2Orbital Floor Machine ORB1420 WARNING: OPERATOR MUST READ AND UNDERSTAND THIS MANUAL COMPLETELY BEFORE OPERATING THIS EQUIPMENT.
Introduction Check the carton for shipping damage. Carefully unpack and inspect your new Powr-Flite dryer for shipping damage. Each unit is tested and thoroughly inspected prior to shipping. If damage is discovered, immediately notify the transportation company that delivered your machine and request an inspection. As a manufacturer, we are unable to act upon any claim for concealed damage; you must originate the claim.
IMPORTANT SAFETY INSTRUCTIONS BEFORE USING A FLOOR MACHINE, BASIC PRECAUTIONS SHOULD BE FOLLOWED, INCLUDING THE FOLLOWING: READ ALL INSTRUCTIONS BEFORE USING THE FLOOR MACHINE. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE WARNING To reduce risk of fire, electric shock or injury: • “WARNING OF POTENTIAL INJURY”. The floor machine contains moving parts, be sure to unplug machine before servicing to reduce the risk of injury. • Do not put any objects into openings.
2 5 1 3 6 4 15 7 11 10 8 9 13 12 14 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 PART LIST SWITCH BOX HANDLE GRIP STARTING LEVER LINE CORD THUMB SWITCH HANDLE TUBE CORD HOOK ADJUSTING LEVER MOTOR CORD WHEELS MOTOR CHASSIS PAD DRIVER PAD ARM BRACKETS LISTA DE PARTES CAJA SWITCH MANGO MANERAL PALPANCA DE ENCENDIDO CABLE ALIMENTACIÓN SEGURO PARA PALANCA DE ENCENDIDO TUBO MANIJA SOPORTE CABLE PERILLA DE AJUSTE CABLE MOTOR RUEDAS MOTOR CHASIS PORTA COJINETE COJINETE SOPORTES DE BRAZO 4
How To Assemble The Pad Always unplug the machine before installing any accessory. 1. Unplug machine, secure handle tube in vertical position and lay down the machine turning it over its wheels until the underneath side of the machine is vertical and fully exposed. 2. Before laying down machine, place a clean towel on the floor to keep the switch box from scratching. 3. Install or replace pad. The pad should be replaced if it has become matted down to a thickness of 3/8” or less. 4.
Advertencias AL UTILIZAR SU PULIDORA, SE DEBEN SEGUIR LAS SIGUIENTES PRECAUCIONES: LEA TODAS LAS INSTRUCCIONES ANTES DE UTILIZAR SU MÁQUINA. GUARDE ESTE MANUAL PARA FUTURAS REFERENCIAS Precauciones Para reducir el riesgo de fuego, choque eléctrico o daño físico: • PRECAUCIÓN DE POSIBLES DAÑOS: La pulidora contiene piezas movibles, desconécte la máquinaantes de darle servicio para reducir el riesgo de daños. • No ponga objetos en ninguna de las aberturas, ni se utilice con alguna abertura bloqueada.
Como Instalar El Cojinete Siempre desconecte la máquina del tomacorriente antes de colocar los cepillos. 1. Desconecte el cable de alimentación, fije el tubo manija en posición vertical y voltee la máquina girándola sobre sus ruedas, hasta que quede horizontal y con el fondo accesible. 2. Antes de voltear el aparato, coloque un paño o material suave y limpio para recargar la caja manija. 3. Instalar o cambiar el pad. El cojinete debe cambiarse sí el grueso del mismo es menor a 3/8” o menos. 4.
Fig.2 Fig.4 Fig.1 2 1 3 Fig.
