User Manual

REPLACING THE AGITATOR ASSEMBLY

Brushes should be replaced when they are worn or when the bristle does not touch a card that is held across the

nozzle. You should replace all four brushes at the same time in order to maintain good cleaning efficiency.

Remove E-clip first from agitator shaft by using screw driver. Then remove the end cap at right end by holding the

agitator assembly. Pull out the agitator shaft from the left end.

NOTE: Take care not to deform the agitator shaft.

Now the brushes can be removed easily. After inserting the new brushes, re-install the agitator pulley and

agitator holder, making sure they are completely and firmly inserted. Reinstall other parts following the steps in

reverse.

Be sure the end caps and filters are in place before fitting the E-clip back into place. Reinstall the agitator

assembly as described in preceding section.

CAUTION:

Unplug the vacuum cleaner.

The nozzle hose, located on the back of the vacuum cleaner, carries the dirt

from the nozzle to the filter bag. The hose also functions as the attachment

cleaning hose. If the hose should become clogged:

1. Pull out and turn the lid of the cleaning attachment opening. Remove the

clog or blockage (Fig. 1).

2. If the above step is not enough, remove hose cuff from the nozzle inlet

(Fig. 2). Turn the unit over and unscrew and remove the bottom plate

(see "How To Remove Bottom Plate."). Check nozzle inlet tube for

obstructions. Clear tube and reinstall the bottom plate.

HOW TO CLEAN THE NOZZLE HOSE

Fig. 1

Fig. 2