User Manual

CAUTION:

First, unplug the vacuum cleaner.

How to Remove the Bottom Plate.

1. Step on Power-Foot label and pull back to release handle.

2. Place vacuum cleaner in the low position. Then turn the vacuum cleaner over, exposing the underside.

3. Remove the lower plate by sliding the two locking tabs towards the center of the vacuum underside. (Fig. 1)

How to replace the belt.

1. Turn the unit over and remove the lower plate as described in the preceding section. (Fig. 1)

2. Remove belt guard. (Fig. 2)

3. Remove the agitator holder. (Fig. 3)

4. Take out the agitator assembly and remove belt from the agitator and the motor drive shaft. (Fig. 4 & 5)

5. Loop the new belt around the agitator and the motor drive shaft. (Fig.6).

6. Reinsert the agitator assembly back into housing Turn the agitator assembly by hand, making sure the belt is not

twisted and all rotating parts move smoothly, (Fig. 7).

7. Reinsert the agitator holder. Be sure that the agitator holder is in place before fastening the lower plate. (Fig. 8).

8. Replace the belt guard.

9. Hook the front end of lower plate to the two ribs on each side at the front end of the housing. Press the lower

plate into place and lock by sliding both locking tabs towards the outside of the vacuum underside. (Fig. 9).

NOTE: To ensure maximum cleaning efficiency, the belt should be checked regularly to be sure it is in good

condition. Check to see if the belt is stretched, cracked, or if excessive slipping is occurring. Replace it if needed.

HOW TO REPLACE THE DRIVE BELT

Fig. 1

Fig. 4

Fig. 7

Fig. 2

Fig. 5

Fig. 8

Fig. 3

Fig. 6

Fig. 9