User Guide

15
Revision 4.0
Threaded spigot mounting.
Use the Drill template below or download the 1:1
drill template from
http://www.poynting.tech/downloads
• Choose a flat mounting location which should
be at least 50cm from heat sources, with a
clear line of sight to the sky.
• Once you have decided on the location and
checked that there are no obstructions such
as cables or channels below the mounting
surface, for the fastening nut and cables to
pass through, use the downloaded 1:1 drill
template to mark the mounting location.
• To prevent the marking tool or drill sliding off
course, use masking tape over the drilling
point to help hold the drill point in place. The
masking tape also prevents hot shavings from
the drill or hole saw which could penetrate and
damage the painted surface.
• Drill the required hole.
• Clean the entire surface on which you plan to
mount the antenna. Cleaning is done so as not
to damage the vehicle’s paint and to ensure
good contact of the foam surface to the
mounting area.
• Alcohol wipes can be used to remove oil and
dirt from the surface.
• The 37mm threaded Spigot should be used to
secure the antenna to a surface structure of
22mm thickness or less. Likewise, the 85mm
threaded Spigot should be used to secure the