User Guide
16
Revision 4.0
antenna to a surface structure of 70mm
thickness or less.
Securing the antenna
• Fasten the required spigot with the Flat head
screws.
• Clean the plastic surface of the antenna base
and threaded spigot.
• Peel off the top wax paper layer from the
spigot mount adhesive foam seal and stick
the foam seal to the antenna surface.
• Carefully slide the cable through the drilled
hole.
• Peel off the second wax paper layer and firmly
press the antenna down onto the surface.
• Tighten the nut so that it compresses the
foam seal
Note: Be careful not to over tighten the nut