User Guide
18
Revision 4.0
Adhesive mounting
• Clean the entire surface on which you plan to
stick the antenna. Alcohol wipes can be used
to remove oil and dirt from the surface.
• Remove the nut, foam seal, flat head screws
and short spigot from antenna.
• Put the foam seal back through the cables and
towards the base of the antenna.
• Peel off the wax paper layer and stick the
adhesive mount foam seal to the bottom
antenna surface.
• Peel off the second wax paper layer and firmly
press the antenna down onto the surface.
• Route the cable as required.