User Guide

10 A-WLAN-0061_PCL
Antenna Mounting Precautions
4
• Place the antenna at the highest point
possible and ensure that there aren’t
any surrounding obstructions to the
antenna.
• In order to avoid communication
interference, ensure that the antenna
is placed at least 0.5m away from other
antennas and metal objects.
• Avoid installing the antenna near
a chimney, as the smoke and soot
emitted by the chimney can obstruct
the signal level achieved by the
antenna.
• Install the antenna away from heat
sourcesandammablegases.
Cable Gland Preparation
6
1. Insert back housing over 2/3/4x
cable
2. Fit the rubber seal over cable by fitting the
cable through the slot.
3. Insert main body with black housing conical
seal, over cable
4. Push rubber seal into the housing main body
until flush.
5. Finally screw back housing on to main body
6. Terminate SMA(m) to SMA(f) located on the
antenna as required.
Connector
housing
Gland seal
Nut
Main Body
Back housing connical seal
Back housing
Enclosure Wall
RF Coaxial cable
SMA(m) conn.
Spanner
Rubber Seal with slot