User Guide
8 A-WLAN-0061_PCL
MountingConguration
3
1. Pole Mounting
• Lay the antenna out at the installation site.
• Attach the cast U-shape bracket component
to the antenna by means of four M6 washers,
three M6 x16mm hex bolts and one M6x12mm
hex bolt-which goes into a point marked
earthing point.
• Use two M6 x 25mm hex bolts, two M6 nylock
nuts, two M6 washers to attach Cast-U-shape
and Cast square on two opposite ends of the
Cast connector rod.
• Attach the assembly to a mast (diameter
32 ~50mm) using the Cast square base, two
U-bolts, four washers and four M6 nuts.
• Point the antenna in the desired orientation
by swivel adjustment of azimuth and/or ele-
vation in two points.
• Do not overtighten the nuts/bolts onto the
bracket components in all places.
• Mount the antenna so that there is at least
1meter of clearance in all directions around
it and unobstructed line of sight to the cell
tower’s strongest signal.
• Earth the pole.
WLAN-0061 is a pole mountable dual band WiFi
antenna. It can be mounted outdoors on a
pole of up to 50mm in diameter or wall mount.
Follow the instructions below for installation.