SDS

PPG73-400 PPG TIMELESS EXTERIOR LATEX SATIN WHITE
Product name
1.02
Product code
Date of issue
Version
00399317
4 January 2018
Section 15. Regulatory information
titanium dioxide
No.
No.
No.
No.
Yes.
-
benzophenone
Yes.
No.
No.
No.
Yes.
-
octhilinone (ISO)
No.
No.
No.
Yes.
No.
-
Name
Fire
hazard
Sudden
release of
pressure
Reactive
Immediate
(acute)
health
hazard
Delayed
(chronic)
health
hazard
Additional environmental information is contained on the Environmental Data Sheet for this product, which
can be obtained from your PPG representative.
California Prop. 65
WARNING:
This product contains a chemical known to the State of California to cause cancer.
Section 16. Other information
Key to abbreviations
:
ATE = Acute Toxicity Estimate
BCF = Bioconcentration Factor
GHS = Globally Harmonized System of Classification and Labelling of Chemicals
IATA = International Air Transport Association
IBC = Intermediate Bulk Container
IMDG = International Maritime Dangerous Goods
LogPow = logarithm of the octanol/water partition coefficient
MARPOL = International Convention for the Prevention of Pollution From Ships, 1973
as modified by the Protocol of 1978. ("Marpol" = marine pollution)
UN = United Nations
Hazardous Material Information System (U.S.A.)
0
0
0
National Fire Protection Association (U.S.A.)
Health
Instability
Flammability
Health
Flammability
Physical hazards
Disclaimer
The information contained in this data sheet is based on present scientific and technical knowledge. The purpose of this
information is to draw attention to the health and safety aspects concerning the products supplied by PPG, and to
recommend precautionary measures for the storage and handling of the products. No warranty or guarantee is given in
respect of the properties of the products. No liability can be accepted for any failure to observe the precautionary measures
described in this data sheet or for any misuse of the products.
Date of previous issue
1/3/2018
:
Caution: HMIS® ratings are based on a 0-4 rating scale, with 0 representing minimal hazards or risks, and 4 representing significant hazards or
risks. Although HMIS® ratings and the associated label are not required on MSDSs or products leaving a facility under 29 CFR 1910.1200, the
preparer may choose to provide them. HMIS® ratings are to be used with a fully implemented HMIS® program. HMIS® is a registered trademark
and service mark of the American Coatings Association, Inc.
The customer is responsible for determining the PPE code for this material. For more information on HMIS®
Personal Protective Equipment (PPE) codes, consult the HMIS® Implementation Manual.
Indicates information that has changed from previously issued version.
Organization that prepared
the MSDS
:
EHS
:
:
:
:
:
:
2
*
2
0
( * ) - Chronic effects
United States
Page: 12/12