SDS

PPG73-400 PPG TIMELESS EXTERIOR LATEX SATIN WHITE
Product name
1.02
Product code
Date of issue
Version
00399317
4 January 2018
Section 2. Hazards identification
Precautionary statements
Prevention
:
Obtain special instructions before use. Do not handle until all safety precautions have
been read and understood. Wear protective gloves. Wear eye or face protection.
Wear protective clothing. Avoid breathing vapor. Contaminated work clothing must not
be allowed out of the workplace.
Response
:
IF exposed or concerned: Get medical attention. IF ON SKIN: Wash with plenty of
soap and water. Wash contaminated clothing before reuse. If skin irritation or rash
occurs: Get medical attention.
Storage
:
Store locked up.
Disposal
:
Dispose of contents and container in accordance with all local, regional, national and
international regulations.
Supplemental label
elements
:
Emits toxic fumes when heated.
Hazards not otherwise
classified
:
None known.
Photosensitive agents : In case of accidental eye contact, avoid concurrent exposure to
the sun or other sources of UV light which may increase the sensitivity of the eyes. In
case of accidental skin contact, avoid concurrent exposure to the sun or other sources
of UV light which may increase the sensitivity of skin.
Section 3. Composition/information on ingredients
titanium dioxide
≥10 - ≤20
13463-67-7
Mica-group minerals
≥1.0 - ≤5.0
12001-26-2
benzophenone
<1.0
119-61-9
octhilinone (ISO)
<1.0
26530-20-1
Ingredient name
CAS number
%
There are no additional ingredients present which, within the current knowledge of the supplier and in the
concentrations applicable, are classified as hazardous to health or the environment and hence require reporting
in this section.
Substance/mixture
:
Occupational exposure limits, if available, are listed in Section 8.
Mixture
Any concentration shown as a range is to protect confidentiality or is due to batch variation.
Product name
PPG73-400 PPG TIMELESS EXTERIOR LATEX SATIN WHITE
:
SUB codes represent substances without registered CAS Numbers.
Section 4. First aid measures
Eye contact
:
Description of necessary first aid measures
In case of accidental eye contact, avoid concurrent exposure to the sun or other
sources of UV light which may increase the sensitivity of the eyes.
If ingestion, irritation, any type of overexposure or symptoms of overexposure occur during or persists after use of
this product, contact a POISON CONTROL CENTER, EMERGENCY ROOM OR PHYSICIAN immediately; have
Safety Data Sheet information available. Never give anything by mouth to an unconscious or convulsing person.
Remove contact lenses, irrigate copiously with clean, fresh water, holding the eyelids
apart for at least 10 minutes and seek immediate medical advice.
United States
Page: 2/12