Use and Care Manual

UltraLast 13-510 Series
Architectural Coatings PPG UltraLast Interior Latex Paint + Primer Semi-Gloss
PRECAUTIONS
PPG Architectural Finishes, Inc. believes the technical data presented is currently accurate: however, no guarantee of accuracy, comprehensiveness, or performance is given or implied.
Improvements in coatings technology may cause future technical data to vary from what is in this bulletin. For complete, up-to-date technical information, call 1-800-441-9695.
PPG Architectural Finishes, Inc.
One PPG Place
Pittsburgh, PA 15272
www.ppgpaints.com
Technical Services
1-800-441-9695
PPG Architectural Coatings Canada Inc.
1550 rue Ampère, Suite 500
Boucherville (Quebec) J4B 7L4
Architect/Specifier
1-888-PPG-IDEA
WARNING! HARMFUL IF INHALED. HARMFUL IF SWALLOWED. Sanding and grinding dusts may be harmful if inhaled. Do not breathe vapor or
mist. Do not swallow. Keep container tightly closed and sealed until ready for use. Wash thoroughly after handling. Provide fresh air ventilation during and after
application and drying. Avoid the inhalation of dust, particulates, spray or mist arising from the application of this preparation. Use personal protective equipment
as required. Note: These warnings encompass the product series. Prior to use, read and follow product-specific SDS and label information. FIRST AID:
If swallowed, rinse mouth with water (only if the person is conscious). Call physician immediately. Do not induce vomiting unless directed to do so by medical per-
sonnel. If in eyes, rinse with water for 15 minutes. Check for and remove any contact lenses. If on skin, rinse well with water. Wash with soap and water. Get medical
attention if irritation develops. If inhaled, remove to fresh air. Call physician immediately. Contains isothiazolinones. May cause allergic reaction. Keep out of the
reach of children. For workplace use, an SDS is available from your retailer or by calling [phone]. EMERGENCY SPILL INFORMATION: [phone]
(U.S.).
13-510 1/2020
© 2019 PPG Industries, Inc. All Rights Reserved. PPG and the PPG Logo are registered trademarks of PPG Industries Ohio, Inc. UltraLast and Clean-Surface Technology are trade-
marks of PPG Architectural Finishes, Inc.
Stir thoroughly before using and occasionally when in use. When using more than one can of the same color, intermix to ensure color uniformity.
USE WITH ADEQUATE VENTILATION. KEEP OUT OF REACH OF CHILDREN. Read all label and Safety Data Sheet (SDS) information prior
to use. SDS are available through our web site or by calling 1-800-441-9695.
Application Equipment: Apply with a high-quality brush, roller, paint pad, or by spray equipment. Where necessary, apply a second coat and
allow each coat to dry thoroughly before applying the next coat.
Airless Spray: Pressure 1500 to 2000 psi; tip 0.015” to 0.021”. Spray equipment must be handled with due care and in accordance with man-
ufacturer’s recommendation. High-pressure injection of coatings into the skin by airless equipment may cause serious injury.
Brush: Polyester/Nylon Brush
Roller (nap roller cover): 3/8” - 3/4”
Thinning: Do not thin.
Permissible temperatures during application:
Material: 50 to 90ºF 10 to 32ºC
Ambient: 50 to 90ºF 10 to 32ºC
Substrate: 50 to 90ºF 10 to 32ºC
APPLICATION INFORMATION