Use and Care Manual

Speechide 12-310XI Series
Architectural Coatings PPG Speedhide Pro EV Zero Interior Enamel Latex Eggshell
PRECAUTIONS
PPG Architectural Finishes, Inc. believes the technical data presented is currently accurate: however, no guarantee of accuracy, comprehensiveness, or performance is given or implied.
Improvements in coatings technology may cause future technical data to vary from what is in this bulletin. For complete, up-to-date technical information, call 1-800-441-9695.
PPG Architectural Finishes, Inc.
One PPG Place
Pittsburgh, PA 15272
www.ppgpaints.com
Technical Services
1-800-441-9695
PPG Architectural Coatings Canada Inc.
1550 rue Ampère, Suite 500
Boucherville (Quebec) J4B 7L4
Architect/Specifier
1-888-PPG-IDEA
WARNING! HARMFUL IF SWALLOWED. Sanding and grinding dusts may be harmful if inhaled. Do not swallow. Keep container tightly closed and sealed
until ready for use. Wash thoroughly after handling. Provide fresh air ventilation during and after application and drying. Avoid the inhalation of dust, particulates,
spray or mist arising from the application of this preparation. Use personal protective equipment as required. Note: These warnings encompass the product
series. Prior to use, read and follow product-specific SDS and label information. FIRST AID: If swallowed, rinse mouth with water (only if the person is con-
scious). Call physician immediately. Do not induce vomiting unless directed to do so by medical personnel. If in eyes, rinse with water for 15 minutes. Check for
and remove any contact lenses. If on skin, rinse well with water. Wash with soap and water. Get medical attention if irritation develops. If inhaled, remove to fresh
air. If experiencing respiratory symptoms call a POISON CENTER or doctor/physician. Keep out of the reach of children. For workplace use, an SDS is available
from your retailer or by calling [phone]. EMERGENCY SPILL INFORMATION: [phone] (U.S.).
12-310XI 11/2019
© 2019 PPG Industries, Inc. All Rights Reserved. The PPG Logo is a registered trademark of PPG Industries Ohio, Inc. Speedhide is a registered trademark of PPG Architectural
Finishes, Inc.
Stir thoroughly before using and occasionally when in use. When using more than one can of the same color, intermix to ensure color uniformity.
USE WITH ADEQUATE VENTILATION. KEEP OUT OF REACH OF CHILDREN. Read all label and Safety Data Sheet (SDS) information prior
to use. SDS are available through our web site or by calling 1-800-441-9695.
Application Equipment: Apply with a high-quality brush, roller, paint pad, or by spray equipment. Where necessary, apply a second coat and
allow each coat to dry thoroughly before applying the next coat.
Airless Spray: Pressure 1500 to 2000 psi; tip 0.015” to 0.021”. Spray equipment must be handled with due care and in accordance with man-
ufacturer’s recommendation. High-pressure injection of coatings into the skin by airless equipment may cause serious injury.
Brush: Polyester/Nylon Brush
Roller (nap roller cover): 3/8” - 3/4”
Thinning: Do not thin.
Permissible temperatures during application:
Material: 50 to 90ºF 10 to 32ºC
Ambient: 50 to 90ºF 10 to 32ºC
Substrate: 50 to 90ºF 10 to 32ºC
APPLICATION INFORMATION