Manualshelf

Instruction Manual

ManualsBrandsPQ Lighting ManualsStealth FixturesPQ Lighting PQL-84053 LED Stealth Fixtures
12
LED STEALTH™ FIXTURES
INSTALL INSTRUCTIONS
PREMIUM QUALITY LIGHTING®
• www.PQLighting.com
© P.Q.L., Inc. • 2285 Ward Avenue • Simi Valley, CA 93065 • 800-323-8107
Specifications subject to change without notice. Photos and line
drawings may not be to scale and are for general reference only.
WARNING, CAUTIONS AND OPERATING INSTRUCTIONS
• To reduce the risk of death, personal injury or property damage from
fire, electric shock, falling parts, cuts/abrasions, and other hazards read
all warnings and instructions included with and on the fixture box and all
fixture labels.
• Before installing, servicing, or performing routine maintenance upon this
equipment, follow these general precautions.
• Commercial installation, service and maintenance of luminaires should be
performed by a qualified licensed electrician.
• For The installation: If you are unsure about the installation or maintenance
of the luminaires, consult a qualified licensed electrician and check your
local electrical code.
• To prevent wiring damage or abrasion, do not expose wiring to edges of
sheet metal or other sharp objects.
• Do not make or alter any open holes in an enclosure of wiring or electrical
components during kit installation.
• Do not cover any part of the fixture; this can cause overheating.
WARNING: RISK OF FIRE OR ELECTRICAL SHOCK
• Turn o electrical power at fuse or circuit breaker box before wiring fixture
to the power supply.
• Turn o the power when you perform any maintenance.
• Verify that supply voltage is correct by comparing it with the luminaire
label information.
• Make all electrical and grounded connections in accordance with the
National Electrical Code and any applicable local code requirements.
• All wiring connections should be capped with UL approved wire
connectors.
CAUTION: RISK OF INJURY
• Avoid direct eye exposure to the light source while it is on.
• Account for small parts and destroy packing material, as these may be
hazardous to children.
• Suitable for Wet locations.
!
WARNING DISCONNECT POWER BEFORE INSTALLING OR SERVICING.
TRUNNION MOUNTING (POLE)
M8 x 1.2”
90°
M8 x 1.2”
Place the wires into the box,
screw on the back board of
the fixture using the M8 x 1.2”
screw.
3”
M10 x 2.4”
Expansion Bolt
3”
TRUNNION MOUNTING (WALL)
Drill a 0.3” hole into the wall.
M8 x 1.2”
3”
M8 x 1.2”
Place the wires into the box,
screw on the back board of
the fixture using the M8 x 1.2”
screw.
PLEASE FIND A QUALIFIED ELECTRICIAN FOR INSTALLATION. Please read the instructions before you install and use the luminaire.
Product requires top-mounted shorting cap or optional twist-lock photocell installed to operate.
Shorting Cap
Shorting Cap

Summary of content (2 pages)