Operating Manual

3.2 Set Sensor ID:
Edit the Sensor’s ID (As shown on the surface of the Sensor) and descripon,
The Sensor column can be edited with only leers and number, Ex: X33A.
The Sensor ID Column should be inpued with the ID of the according Sensor (As
shown on the surface of the Sensor); Sensor ID is case-sensive.
Hidden Funcon: Aer Sensor ID is set, you may double click on the text “Sensor
ID”, and you will copy the Sensor ID column to the Sensor column.
3.3 Sets the Antenna port for the Sensor: ANT 1 ~ Ant4
Set up Antenna according to on-site tesng; each sensor can have at most 2
antennas simultaneously.
3.4 Get/Set Seng Parameters Funcon:
Get: Gets the current seng parameter of the Reader.
Set: Overwrites and updates the Reader’s sengs with the parameters set.
Small Tip: The Get/Set All buon to the top right corner of this area can Get/Set
all sengs parameter of this area. You can also enable/disable all sensors with the
Sensor Enable/Disable All buon at the top le corner.
Page 13