User's Manual

48
Shipping Guidelines
When shipping the HRT500, follow these guidelines:
● Safeguard data by making a backup copy.
● If shipping the backup copy, be sure that the medium (diskette, tape, or SD
card) is not exposed to electrical or magnetic impulses while stored or in
transit.
● Turn off HRT500 and disconnect all external devices.
● Pack HRT500 and all external devices (such as the cradle, cords, and cables) in
their original packing boxes or in similar packaging with sufficient packing
material to protect them.
FCC STATEMENT :
This device(FCC ID:SX3-HRT500I) complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
SAR Statement:
The device complies with RF specifications when used near at a distance of 0 cm from your body.
Ensure that the device accessories, such as a device case and device holster, are not composed of metal
components. Keep the device away from your body to meet the distance requirement.
This device is also designed to meet the requirements for exposure to radio waves established
by the Federal Communications Commission(USA).
The SAR limit adopted by the USA is 1.6 W/kg averaged over one gram of tissue.
The highest SAR value reported to the FCC for this device type complies with this limit.
The highest SAR value reported to the FCC for this device type when properly worn on the body is 0.121W/kg