User's Guide

ELEDIVALL (AWDD) USER GUIDE
ISELEDIVALL_EN_12_18.pdf p. 1
ELEDIVALL188 – Advanced WDD - Transmitter:
1. GENERAL INFORMATIONS
The transmitter ELEDIVALL188 is a radio module with safety edge input. It is synced with a receiver ELEDIVALL187.
The transmitter communicate with the receiver by radio to send information about safety edge input and battery state.
2. TECHNICAL FEATURES
Power supply :
Lithium battery (non-replaceable)
Average consumption :
2.0µA
Transmission frequency
433.92 MHz
Number of safety edge input ** :
1
Input type :
Dry contact
IP rating :
IP67*
Working temperature :
-30/+70°C
Storage temperature :
-40/+85°C
Size / Weight :
L68x l18x h18 mm / 25g
* Warning IP rating is obtained in the presence of the female connector connected to
the male connector.
** The maximum wire length of the safety edge is 22m (maximum impedance is
300Ohms in detection).
3. TRANSMITTER OVERVIEW:
• Top view:
• Installation:
Accessory: ELEDIVALL189 wire with male connector.
4. OPERATION:
The transmitter has two operating modes:
• One sleep mode: storage mode without radio transmission.
• One active mode: normal operating mode with radio transmission.
Sleep mode:
Into this mode, the transmitter sends no radio transmission (in order to preserve battery life).
The male connector must not be connected.
In sleep mode, the transmitter keeps his configuration in memory.
To get out of sleep mode plug the male connector of the wire ELEDIVALL189 to the female connector of the transmitter ELEDIVALL188
and make a contact between the two terminals of the wire.
To return in sleep mode, you have plug the sleep tool to the female connector. Once the transmitter turned in sleep mode, you can unplug
the tool. The transmitter will stay in sleep mode until the wake-up sequence is executed.
Active mode:
In normal operating mode (battery with enough power to make a radio transmission):
• The transmitter scans the safety edge input and sends information to the receiver :
o Safety edge input activated
o Safety edge input activated continuously during more than 10s (In this state, the safety edge input is scanned every
5s to determine if it is still activated. If still activated, no new radio confirmation is sent to the receiver).
o Safety edge input returns to standby mode after being activated more than 10s.
• Every 30s, the transmitter measures its battery voltage and send measurement result to the receiver.
Summary table of operating status and signalling:
The LED indicator is activated each radio frame transmission. The number of flashes indicates the type of radio frame transmitted
according to the following table:
Blinks numbers
Radio frame transmitted
2
Safety edge input activated
3
Safety edge input activated more than 10s
4
Safety edge input activated freed after more than 10s activation
1
Presence
10
Switch to sleep mode
Power supply
ELEDIVALL188 power supply is made by a non-replaceable lithium battery: if the battery is defective do not try to replace it. To preserve
the environment, dispose of the battery according to the regulations in force.
Female
connector
1
2
Signaling LED