Installation Instructions

Multi-Piece Sectional Product
Installation Instructions
INSTALLATION INSTRUCTIONS FOR SHOWER
SEATS WITH SWING DOWN LEGS
(This style seat has four (4) adjustable height legs)
Your seat with swing down legs is fully assembled. Remove
it from the box and proceed as follows:
1. Choose the height of the seat you want. Barrier Free
style showers will typically have fold up seat installed at 17”
to 19” height.
2. After selecting the height you desire, adjust each of the
four legs to that height while maintaining the seat in a level
position. Lock each of the lock nuts.
3. Place the seat against the wall of the shower where you
want the seat to be located. Seat may be centered on the
wall for a Barrier Free installation.
4. With the seat placed against the mounting wall, position
the two hinges to the wall. Using a pencil, mark the three
holes (3) holes in the ange onto the wall for each hinge.
Remove seat from wall.
5. Using a power drill with a 0.120” diameter drill through
the wall the three (3) mounting holes for each ange.
6. Apply silicone caulking around and inside each drilled
hole before installing the seat.
7. Place the seat against the mounting wall with each hinge
aligned to the mounting holes. Utilizing the six (6) #10 x 2”
Stainless Steel screws, place a Phillips screw driver into your
power drill and securely tighten each of the six (6) screws.
THIS COMPLETES THE INSTALLATION OF THE SEAT
INSTALLATION INSTRUCTIONS FOR GRAB
BARS
Recommended tools for installation:
1/4” Power Drill
1/8” drill bit when drilling through berglass
#2 Phillips Screw Driver and/or Phillips drill insert
1/2” Open end wrench or a small Crescent wrench
Tape measure
Pencil/pen
Center Punch
Silicone Caulk
1. As indicated earlier in this manual, wood reinforcements
must be solidly installed behind the tile wall surface to provide
a secure mounting surface to attach the grab bars. Grab bars
must be installed at these locations only.
2. Select the particular size and style of grab bar you want to
install. Certain grab bars have snap in place ange covers, and
others have exposed anges.
3. For grab bars with snap in place ange covers, use the
handle of a Phillips screw driver to tap back the covers on
the bottom edge of the covers. It will be convenient in the
installation process if the covers are tapped together in the
center of the grab bar.
4. Determine the position you want the to install the bar.
Place the bar against the wall. Using a pencil, mark the location
of each mounting hole at both ends of the bar.
5. Using a power drill with a 1/4” diameter carbide tipped drill
bit, drill, each mounting hole.
6. Apply silicone caulking around and inside each drilled hole
before installing the grab bar.
7. Take two (2) of the #10 x 2” Stainless Steel screws. By
hand, start one mounting screw in each end of the bar into
the wall.
8. Use a power drill with a Phillips drill bit to fully install these
mounting screws.
9. Take the remaining #10 x 2” screws and place them into
the remaining open holes. Use care to snug up the screws,
but to not over-torque that the screws strip out the factory
installed backer board.
10. If installing a bar with snap-on covers, move the covers
into place at each ange. Twist the covers clockwise or
counter clockwise to tighten the covers onto the anges.
THIS COMPLETES THE INSTALLATION OF THE GRAB BAR