User's Manual

370-xxx-1A

sensor and reports this to the operator display. The sensor is designed to process and report

detections within ½ of a second allowing the vehicle operator to quickly respond to any object

within the detection zone. All connections to a vehicle are accomplished at the sensor. Power

is obtained from the vehicle reverse lights and a relay contact is provided for operating a back

up alarm. The connection to the display unit is through a watertight connector eliminating any

potential problems with pin corrosion. Power to the operator display is provided through the

sensor interface to the display. The sensor RF output is pulse modulated so that it will not

interfere with similar devices.

Operator Display Description

The operator display provides the vehicle operator with both visual and audible indications of a

detected object. Range to the detected object is provided with five LED’s. Each LED

represents 1/5

of the total range. Example: For the WB2015, each LED represents 3 feet.

The display unit also contains a buzzer to provide an audible alert that will increase in rate as

an object becomes closer, providing the operator with another cue that an object is being

detected.

The operator display continuously monitors communication from the WideBand PreView

sensor and in the event of a system failure or malfunction will notify the operator with a fault

indication

A buzzer volume control switch is provided on the front panel of the display allowing the

vehicle operator the ability to adjust the buzzer volume to four different levels.

Buzze

olume Control

Switch

Power On

LED

Range Indications

5 Zones