Owner's Manual AMPLIFIER DCX 500.1, DCX 1000.1, DCX 1500.1

12. -12dB Input Attenuation: Push this switch ‘IN’ for high voltage
(4V-12V) capability. This button pushed ‘IN’ must be used for
speaker level input on common ground head-units or for high
voltage line drivers.
13. Phase: Adjust the phase of the output relative to the amplifier
input.
14. RCA Outputs: RCA outputs provide HP/LP/FULL 30-4kHz
signal to another amplifier.
DCX-500.1, 1000.1, 1500.1 END PLATE DIAGRAMS
1. Power/Ground PowerLock
TM
: After you have securely
connected your power and ground wires, plug in the Power/Ground
PowerLock
TM
connector here. Note that the DCX1000.1 and
1500.1 have two of these receptacles.You must connect the power
and ground cables to both
PowerLock
TM
terminals for optimum
operation.
2. QBASS REMOTE
TM
: Plug in the data cable from the optional
QBASS REMOTE
TM
dash mounted level control here. (The remote
level control will bypass the amplifier’s on board QBASS
TM
control.
1 1 2 3
4
DCX1000.1, 1500.1
Rear Panel
QBASS
REMOTE
QBASS
0 +16
DCX500.1
Rear Panel
QBASS
REMOTE
QBASS
0 +16
1 2 3 4
14