Specifications

The cables should be connected to the passive crossover,
the woofer, and the tweeter as shown on diagram 1. Polarity
must be observed on both the speakers and crossover.
Now that the cables are in place on the crossover they can be
connected to the speakers. Gently push the wire terminals
onto the speaker terminals. On the speaker the smaller
terminal is the negative lead and the larger is the positive lead.
Insure that the correct wires are connected to the woofer and
the tweeter otherwise damage will occur!
Do not connect either speaker lead to ground or to a 12
volt power source. Your speakers, amplifier, or head unit
can be damaged!
After the woofers have been wired they can be mounted to the
speaker baffle using the factory hardware or the supplied
mounting equipment. Use whichever will work best for your
needs. The tweeters can be mounted next following
diagram 2 to either flush or surface mount the speaker.
Now that the speakers are wired and mounted the system
should be tested for proper operation. If it is operating
properly the grille or panel can be reinstalled and the
speakers for the other side can be installed. If the system is
not working as it should refer to the troubleshooting chart on
page 11.
Reinstall the grille or panel by reversing the steps followed in
the removal of the component. Install all screws and fasteners
securely to avoid potential rattles and other problems. The
other speakers can be replaced by following the same
procedure.
If a non-factory installation is your choice, be careful when
cutting into your vehicle. Make sure any panels that are to be
cut are free of any obstructions on both sides.
8