User's Manual

1. Installation
1.1 System Requirements
This keyboard requires a PC with USB connection and one of the following operating systems:
Windows 98SE / ME / 2000 / XP / Vista
For the installation of the keyboard under the mentioned above operating systems you need NO
special driver!
1.2 Installation of the USB receiver
In order to install your keyboard, please perform the following steps:
Connect the included USB receiver (dongle receiver) to a free USB port on your computer.
Advise:
Please ensure, that the USB receiver has a minimal distance of 20 cm to metallic dividing walls,
other computer cases, monitors, ZIP drives, loudspeakers and switching power supplies.
All mentioned above state-of-the-art operating systems with Plug & Play support will recognize
your keyboard automatically and load the required drivers. During the phase of installation your
operating system informs you via changing Pop-up information windows on the task-bar about
the current status of installation. Please be patient, until the system informs
you finally about the successful installation.
The USB receiver is now ready for operation.
1.3 Installation of the keyboard
Recommended requirement for that is the successful installation of the USB receiver under
point 1.2.
If you haven’t done yet, remove the covering of the battery case on the bottom of your keyboard.
Install the included batteries of type AAA 1.5 V considering the right polarity in the battery case.