User's Manual

In implausible case the keyboard does not work even after new-synchronisation, you have the
following options to solve this problem:
Repeat the procedure including the hardware reset of the USB receiver (conventional
synchronisation) by pressing at first the LED key on the USB receiver (blue LED of the USB
receiver flashes 3 times in a row) and only now the PAIRING key on the back side like
mentioned above. In very rare cases it is necessary to repeat this routine several times until
the right “radio channel” was found.
2. How to use the keyboard
After successful launch enjoy now during the operation a free and independent choice of
location up to approx. 10 m distance to the PC. More or less range can be caused, like
mentioned above, by metallic dividing walls, other computer cases, monitors, ZIP drives,
loudspeakers, switching power supplies etc., but also by different loading capacity of the
batteries. For this, the status LEDs on front side of the keyboard give you information about
the current operating condition.
2.1 Meaning of status LEDs
Pairing-LED
indicates that the keyboard and the USB receiver are in Pairing-Mode, that means during
manual initiation of the new-synchronization routine to one shared “radio channel” (ID). It goes
out after successful synchronisation.
Transmitting-LED
indicates during key actuation that all input information have been sent out successfully per
radio transmission from the keyboard.
Battery Low-LED
indicates that the load condition of the batteries is below 2.4 Volt. It flashes until a new battery
was inserted or the battery was used up completely.
Besides it flashes only when the keyboard is not in Sleep-Modus (idle state).