User's Manual

ManualsBrandsPrecision Squared Technology ManualsComputers & AccessoriesRF 2.4G Wireless Keyboard

Operation Manual

1. Installation

1.1 System Requirements

This keyboard requires a PC with USB connection and one of the following operating

systems:

Windows 98SE / ME / 2000 / XP / Vista

For the installation of the keyboard under the mentioned above operating systems you

need NO special driver!

1.2 Installation of the USB receiver

In order to install your keyboard, please perform the following steps:

Connect the included USB receiver (dongle receiver) to a free USB port on your

computer.

Advise:

Please ensure, that the USB receiver has a minimal distance of 20 cm to metallic

dividing walls, other computer cases, monitors, ZIP drives, loudspeakers and

switching power supplies.

All mentioned above state-of-the-art operating systems with Plug & Play support will

recognize your keyboard automatically and load the required drivers. During the

phase of installation your operating system informs you via changing Pop-up

information windows on the task-bar about the current status of installation. Please be

patient, until the system informs you finally about the successful installation. The

USB receiver is now ready for operation.

Summary of content (4 pages)

PAGE 1
Operation Manual 1. Installation 1.1 System Requirements This keyboard requires a PC with USB connection and one of the following operating systems: Windows 98SE / ME / 2000 / XP / Vista For the installation of the keyboard under the mentioned above operating systems you need NO special driver! 1.2 Installation of the USB receiver In order to install your keyboard, please perform the following steps: Connect the included USB receiver (dongle receiver) to a free USB port on your computer.
PAGE 2
1.3 Installation of the keyboard Recommended requirement for that is the successful installation of the USB receiver under point 1.2. If you haven’t done yet, remove the covering of the battery case on the bottom of your keyboard. Install the included batteries of type AAA 1.5 V considering the right polarity in the battery case. Switch the I/O sliding switch to ON position! Advice: The USB receiver and the keyboard are factory-made already synchronised on the same channel.
PAGE 3
the PC. The process of synchronisation can take up to 10 seconds and is signalised by flashing up of the PAIRING-LED (left LED on front side of the keyboard), which goes out after successful procedure. The keyboard is now re-synchronised. Check now the functionality of the keyboard like described under point 1.3.
PAGE 4
successfully per radio transmission from the keyboard. Battery Low-LED indicates that the load condition of the batteries is below 2.4 Volt. It flashes until a new battery was inserted or the battery was used up completely. Besides it flashes only when the keyboard is not in Sleep-Modus (idle state). 2.