User Manual

Battery Low-LED
indicates that the load condition of the batteries is below 2.4 Volt. It flashes until a
new battery was inserted or the battery was used up completely.
Besides it flashes only when the keyboard is not in Sleep-Modus (idle state).
2.2 Special operation modes of the keyboard
Sleep-Mode
When 30 minutes happens no input in your keyboard respectively touchpad, the
keyboard turns automatically into Sleep-Mode (idle state) to save battery capacity.
Wake up-Mode
For activating the keyboards from Sleep-Mode press any key on your keypad
(not the left or right mouse function key of the touchpad or the touchpad itself!).
Reconnect-Mode
After reactivation the keyboard connects automatically again with the USB receiver.
Depending on environmental conditions for the radio transmission it needs for that
between less than 1 second up to few minutes.
3. Power Source
It uses NI-MH rechargeable battery as the main power source. If the voltage level of
battery is below 2.00 V which can be seen as the battery low led flashing, please use
USB power to charge the battery via a cable equipped mini-B male connector. The
mini-B female connector on board is used for battery recharging purpose only.
CAUTION:
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
The users manual or instruction manual for an intentional or unintentional radiator
shall caution the user that changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate the
equipment.