User Manual

successfully per radio transmission from the keyboard.
Battery Low-LED
indicates that the load condition of the batteries is below 2.4 Volt. It flashes until a
new battery was inserted or the battery was used up completely.
Besides it flashes only when the keyboard is not in Sleep-Modus (idle state).
2.2 Special operation modes of the keyboard
Sleep-Mode
When 30 minutes happens no input in your keyboard respectively touchpad, the
keyboard turns automatically into Sleep-Mode (idle state) to save battery capacity.
Wake up-Mode
For activating the keyboards from Sleep-Mode press any key on your keypad
(not the left or right mouse function key of the touchpad or the touchpad itself!).
Reconnect-Mode
After reactivation the keyboard connects automatically again with the USB receiver.
Depending on environmental conditions for the radio transmission it needs for that
between less than 1 second up to few minutes.
Warning:
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.