Owner manual

Turning the Aux channel On/OFF

The Aux Channel can be used as a 2nd control channel or it can function as a Live Data readout

and logging channel. If the Aux channel is ON (configured for control) the Display will show the actual

psi value on the Aux channel. Note—This is the pressure on the control side. And the data log will repre-

sent the Actual target psi on the control side.

If the Aux channel is OFF and a MAP sensor is connected to the manifold the Display will pro-

vide a live readout of the Actual Manifold Boost pressure. The data log will represent the actual manifold

pressure.

Refer to the Selecting MAP Sensor

and the Installation section for more information...

Press the OPTION button.

Press the NEXT button twice.

2 3

Press the AUXOUT button to Tog-

gle the Aux Channel ON/OFF.

IMPORTANT INFORMATION

If no MAP sensor is detected this

message will be displayed and the

Aux Channel will remain OFF!

Setting Launch, Shift, Scramble, and Reduce polarity

The Launch, Shift, Scramble, and Reduce inputs can be configured for +12 volt or Ground acti-

vation. This way existing wiring and/or switch setups can be used.

Press the OPTION button.

Press the NEXT button twice.

2 3

Press the INPUT button.

Continued on Next Page.

Click for Index.

Back

NOTE—Target Psi is the amount applied to the waste gate and is NOT the actual Manifold Boost Psi!