PERFORMANCE Wireless Backup Camera System Model No. ACA020&ATBOOO Owner’s Manual and Warranty Information Read these instructions completely before using this product.
SAFETY PRECAUTIONS A This safety alert symbol indicates they a potential persona Injury hazard Bs present. The symbol ia usually used with a signal word {e.
INTRODUCTION He Back-Up Cormeraodisplays rages berate the vehicle, and Is used when backing up a vehicle, Tier this vehicle ib driven in reverse, the camera bs activated, witch seed 2 sign Se manometer Fhe arenas sends a video sigma to fe monitor, which then displays he view captured by the camera, goo Odor monitor displays view from the rear of the vehicle Wireless monitor can be suction-mounded to windshield or dash for easy visibility Adjustable monitor mowing am Adjustable various camera angle Weatherpr
INSTALLATION tf ea Some states or local governments may have regulations or laws that restrict the use of anything halt might impair the clear view of 8 license plate. Check local laws for complains, For the Back-Up Camera to be properly instated, it must be wired into the vehicle's taillight harness. I you are not comfortable or knowledgeable with 12-coll DC wiring, have the system professionally installed.
&. install he license plate screws to secure the came Bo the vehicle, 8. Determine which are the postie (4) and additive (4) wires Tor the reverse lights on the vehicles, Yous pars use lather the right or leftwards reverse light wires. For help orating the vehicle's revs mes Eight roulette, cord act wou vehicle's manufacturer specification wiring ding reams. 7. Remove be vehicle's negative {) battery cables, 8.
Legend To Wire rom Vehicle 2 Wire from Transmitter 12. Crimp the metal clamp using a pliers to ensure a good compaction avd then close the kek of the wire archdeacon, Do this for boll the positive and negative wires from the reverse tight, 18. Mount He costumier In se area whens the wire Fromm the camera aan be plugged into i 4, Connect the vehicle's negative +) battery cables, 15. Plug the transmitter power cons plug Into the transmitter power port.
monitor Controls Legend Menu Bunion Up Button OR OFF Butters Dons Button Guidelines Button Bus Power LED PY gS ps CHAFF Button Press to turn Hee Replay ors, Press i again to ure the display off Blue Power LED The LED will be on when the monitor fs turned or Adjusting Monitor Settings To adjust the following monitor seedlings.
Bie Lie Ey 6 Storage Shore this Back-Up Corners In a cool, dry ares and keep away om dissect sunlight, heat, excessive humidity and depress, Cleaning Dio not clean of wipe he Back-Up Camera with solvents or chemical materials. if necessary, remove ait or stands using @ soft doth airdropped with a mid detergent solution, Fuse Replacement 1. Turn the cop on the poof the power plug counterclockwise {no ols needed), 2. Remove the cap, center pin ard fuse. 3. Feckless the fuse with a new T-amp fuss. #4.