User's Manual

WARNING: Do not pull or remove the rearview mirror
without pulling apart the tension clamp.
CAUTION: The instructions may not apply to every type
of vehicle. For vehicle specific questions, contact your
vehicle’s manufacturer to be sure that the installation and
mounting will not degrade the safety of any system or device
on your vehicle, including Federal Motor Vehicle Safety
Standards.
POWERING
NOTE:
• Power up monitor using 12V adapter provided
• Route the cord of the 12V adapter where it does not obstruct
your vision or degrade the safety features of the vehicle
• Use the optional hardwire mirror power cable to connect the
CAMERA INSTALLATION
Install Rearview Vehicle Backup
Camera in the top of the vehicle’s
rear license plate to achieve
maximum viewing angle.
1) Remove license plate from rear
of vehicle.
2) Locate reverse tail lights and
select a wiring route the camera
will use for its power source.
3) Inspect and determine
route of camera wiring
to reverse lights.
4) Insert camera wire
through grommet
(supplied). The
Signal Booster
camera
power
wires
mirror to constant power without using the 12V Charger.
1. Plug 12V adapter to vehicle cigarette lighter socket.
grommet protects the
wire from the metal
edge.
Backup Camera
power source
2. Connect adapter to monitor power port.
3. Press monitor’s “ON/OFF” button
NOTE: UNDER EXTREME BRIGHT LIGHT CONDITIONS, THE SCREEN
IMAGE MAY TAKE A FEW SECONDS TO STABLIZE. PLEASE WAIT
UNTIL THE IMAGE HAS STABLIZED BEFORE BACKING UP
5) Check for openings or holes where license plate is
mounted to insert camera wires. If no opening is
available, drill a small hole and insert wire. Select a
location close to the camera’s power cables.
Note: The Rearview Mirror Vehicle Backup Camera can
be installed without drilling a hole by using a pre-existing
hole on the vehicle to route the wires to the reverse
taillights.
CAUTION: Take extra precaution necessary to avoid
vehicle damage. Before drilling, inspect behind the
drilling location to ensure there are no vehicle wirings or
components.
6) Insert camera wire into selected or drilled opening.
10