User's Manual

7) Plug the camera wire to
the signal booster. Ensure
wires are not obstructed or
tangled.
8) Remove light socket from its
reverse light housing.
CAUTION: It is highly
recommended that you remove the
bulbs as a precaution.
9) Connect camera power wires
camera wire
NOTE:
• Place and secure the signal booster where you can get
the best signal
• It is recommended to get the signal booster as
close to the front of the vehicle where the monitor is
installed.
CHECKPOINT:
At this point, you can check if you properly connected the
wires by:
• Reconnecting the battery.
CAUTION: Before connecting camera wires, use a
Volt Meter or a Multi-Meter to determine positive and
the negative wires on the vehicle’s reverse light wires.
Vehicle wiring may vary. Refer to the vehicle Owner’s
Manual for more information.
a. Determine positive and negative wires. Most vehicles
will have two color wires, BLACK for negative and
RED for positive.
b. Disconnect vehicle battery before proceeding to the
next step as a precaution
c. Using the Scotch-Lok Connectors, connect camera’s
RED wire to reverse light’s positive wire. If needed,
use pliers to squeeze Scotch-Lok and ensure a good
connection.
d. Connect camera’s BLACK wire to reverse light’s
negative wire. Secure and link wires using the Scotch-
Lok Connectors.
e. Secure wires with cable
• Turn the ignition to the “Accessories” position.
• Engage the Emergency or Hand Brake.
• Put the vehicle in reverse.
• Press “On/Off” button of the Monitor.
If the camera and the monitor wirings are hooked up
correctly, the monitor should turn on and should display
image of rear view of the vehicle.
**Disconnect vehicle battery before proceeding with
installation**
11) Connect bulb back into light socket.
12) Reinstall light socket into reverse light housing.
13) Slide license plate between camera and mounting
14) Align camera mount to license plate.
NOTE: For maximum viewing, place camera on the
center of the license plate.
15) Use double sided tape to secure the camera onto the
license plate.
NOTE: Press license plate and camera mounting firmly
ties or electrical tape.
10) Plug camera power wires
to the signal booster
11
camera power wire
to secure and get full contact between the license plate
and the double-sided tape.
16) Screw license plate with camera onto rear of the vehicle.
17) Once camera is secured, adjust camera angle to desired
point of view.