Product Manual

6
Operating power is obtained from a 12 volt Battery .
Be sure to connect the red to the positive (+)
source and attach the black to the negative(-)
source.
Figure 8B
8B. Attach Lead to connectors coming out of arm as
shown in Figure 8B
(Hang excess wire slack on notch located on pulley
bar
Detail View 1:
Feed dump rope through swivel pulley on pulley bar,
through swivel pulley on chassis assembly, through
stationary swivel on upper hopper bag. Tie end of
rope to Carabiner Clip. Chassis Pulley may need
adjusted after assembly. See Figure 9
Swivel Pulley
Swivel Pulley
Stationary Pulley
Carabiner
Clip
Figure 9
NOTES
Detail
View 1
Detail View 2
Detail
View 3
STEP 9: Dump Rope Setup
Detail View 2:
Detail View 3:
5
STEP 7: Hopper Assembly
7A. Secure Hopper Overflow Lid to Hopper using two
8 x 40mm hex head bolts and two M8 nuts.
See Figure 7A.
Overflow Lid
8 x 40MM Hex Bolt
Figure 7A
3. INSIDE VIEW
4.REAR TOP VIEW
Hitch Pin
Detail View
Clevis Pins 2.2 x
40
M8 x 20
Hex Head
Bolt Sets
Figure 6B
R.H. Upper Side Tube
L.H.
Upper
Side
Tube
1. INSIDE VIEW
2. REAR BOTTOM VIEW
6c. Attach Support Rods to Hopper. See Following
Steps 1, 2, 3 & 4.
Insert Support
Rods through
Lower Frame
Tube and
through
riveted holes
in Hopper Bag.
Secure with Hitch
Pin Clips
Support Rods
Hitch Pin Clips
Support Rod
Raise Rear
Hopper Tube
up and extend
Support Rods
up and place
into riveted
holes and
Upper Rear
Frame Tube
Secure with two
Hitch Pin Clips
STEP 8: Connect Sweeper Motor
8A. Attach sweeper motor to connectors (black to
black, red to red) coming out of arm as shown in
Figure 8A.
Figure 8A
Sweeper Motor