Operating Manual

FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits of a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
and correct the interference.
INDUSTRY CANADA STATEMENT
Per RSS-Gen, Section 8.4 This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired operation of
the device.
Per RSS - Gen, Section 8.4 Cet appareil est conforme à Industrie Canada exempts de licence standards
RSS. Le fonctionnement est soumis aux deux conditions suivantes : (1 ) ce dispositif ne peut pas
provoquer d'interférences et ( 2) cet appareil doit accepter toute interférence , y compris les
interférences qui peuvent causer un mauvais fonctionnement de l'appareil.
This radio transmitter, 20379-PRECOLINK, has been approved by Innovation, Science and Economic
Development Canada to operate with the antenna type listed below, with the maximum permissible gain
indicated. Antenna types not included in this list that have a gain greater than the maximum gain
indicated for any type listed are strictly prohibited for use with this device.
Manufacturer: Antenna Factor by Linx
Model number: ANT-2.4-ID-2000-SMA
Peak Gain: 3.0dBi max
Impedance: 50-ohms
REGULATORY COMPLIANCE
The PreView Side Defender
®
II sensor is compliant with the following countries/regions and their
regulations as of the published date of this manual. The sensor may be compliant in other
countries/regions. Please check your local regulations or contact PRECO Electronics
®
for support.
• United States - FCC- Part 15.247
o FCC ID: OXZPCLK2020
• Canada - RSS-247:2017
o IC ID:20379-PRECOLINK
• European Union - ETSI EN300 328 V2.3.3:2019-07. ETSI EN301 489-17 V3.1.1:2017
• Australia/New Zealand – AS/NZS 4268:2017
Patent pending
This document may be amended, corrected, and enhanced in keeping with the sensor development
progress. The most recent version can be found at www.preco.com
TRADEMARKS
The names of actual companies and products mentioned herein may be the trademarks of their
respective owners. Any rights not expressly granted herein are reserved.