Service manual

9.25, 9.25i Treadmill
Page 28
Procedure 6.2 - Replacing the Speed Sensor
WARNING
Always turn off the circuit breaker and unplug the treadmill before you remove the treadmill hood.
Removing the Speed Sensor
1. Remove the hood.
2. Disconnect the speed sensor cable from the lower PCA.
3. Remove the nut that secures the speed sensor to the speed sensor bracket. Set aside the
speed sensor.
Replacing the Speed Sensor
4. Position the speed sensor next to the speed sensor bracket. Install the nut that screws the
sensor to the bracket.
5. Connect the speed sensor cable to the lower PCA.
6. Inspect and adjust the gap between the speed sensor and the target as described in
Procedure 3.4 of the Residential Treadmill Service Manual.
7. Check the operation of the treadmill as described in Section Three of this appendix, then
replace the hood.