Service manual

9.25, 9.25i Treadmill
Page 8
Procedure 2.3 - Resetting All User Information
This procedure completely resets the M9.25 user statistics. All previously-saved user information
will be either reset to zero or changed to default values. All odometers will be reset to zero. If you
want to save accumulated user information and odometer readings, record the information
before performing this procedure.
Note: This procedure is not available on the 9.25i. User stats must be reset individually per
Procedure 2.4.
Procedure
1. Plug the power cord into the wall outlet, then turn on the treadmill with the circuit breaker.
2. With the PRECOR M9.25 or PRECOR M9.25i banner scrolling, press the INCLINE
▲,
INCLINE
▼, SPEED ▲, and SPEED ▼ keys simultaneously and hold them for approximately
five seconds (or until zeros are displayed in the right display windows). Release the keys.
3. Watch the electronic display. The right middle display window:
a Resets to all zeros, then increments to 119
b Resets to 1000, then increments to 1119
c Resets to 2000, then increments to 2119
d Resets to 3000, then increments to 3119
e Displays the User ID prompt.
Note:
If the upper PCA or prom is replaced, all user information will be re-initialized.