Owner`s manual

page 3
COMMERCIAL PRODUCTS DIVISION
You do not need any special knowledge or experience to set up a C764 climber,
however you will need assistance. Ask for one or more assistants to help you
assemble the climber. You will also need to obtain a socket wrench and a set of
Allen wrenches.
INSTALLATION REQUIREMENTS
Follow the installation requirements below when installing the climber. If you do
not install the climber according to the following guidelines, you could void the
Precor limited warranty.
• Set up the C764 climber on a solid, flat surface. A flat surface is required
for your safety and proper use of the climber.
• Fill out and mail the limited warranty card. The serial number is located
on a label underneath the right foot pedal as you face the electronic console.
• Use the appropriate voltage, dedicated circuit, and grounding as
specified on the climber. The C764 climber is available in a 120-volt model
in the U.S.A. and Canada. A 240-volt model is available for the European
and international markets. Refer to the climber’s identification label to
determine the voltage that your climber requires. The C764 climber’s 120-
volt and 240-volt models require a dedicated 15 amp circuit. Failure to use
a dedicated circuit might damage the unit and void the manufacturer’s
limited warranty.
CAUTION: Do not use a non-grounded outlet. Do not remove or otherwise
bypass the plug with an adapter. Electrical damage can occur if the C764
climber is connected to an improper power source.
ASSEMBLY INSTRUCTIONS
To assist you in the assembly of the climber, the items in the hardware kit, shown
in Diagram 1, correspond to a particular letter in the alphabet. These letters
appear throughout the assembly instructions. Refer to Diagram 1, while perform-
ing the following steps:
Note: Before assembling the climber ask for assistance from other adults and
acquire a socket wrench and a set of Allen wrenches. Refer to the C764
Addendum for assembly instructions regarding the vertical handlebars.
1. Unpack the climber and remove the packing materials from the handrails,
upper column support, electronic console display, and base frame
assembly.
Setting Up the C764 Climber