Owner`s manual

page 4
COMMERCIAL PRODUCTS DIVISION
2. Remove the climber from the shipping pallet. Be sure to remove the lag bolt
that holds the climber on the pallet. The lag bolt is located under the right foot
pedal next to the casing. Ask for assistance to lift the climber off the shipping
pallet.
CAUTION: To avoid injury and ensure your safety, you need assis-
tance to lift the climber off the pallet and place it on the floor. Do not
drop the unit.
3. Make sure that the climber is unplugged and turned OFF. Do not assemble
the C764 climber if it is plugged into a power outlet.
4. Take the following steps to secure the upper column to the base frame
assembly:
a. Place four split washers (B) found in the hardware kit onto the hex head
screws (A).
b. Position the upper column above the base frame mounts so that the
handrail clamp (on the upper column) faces the foot plates. Slide the
rubber boot up the column to expose the mounting holes.
c. Align the mounting holes and insert the screws (A) through the column
support mount and into the base frame mount. See Diagram 2. Finger-
tighten each screw. Use an appropriate socket wrench and alternately
tighten each screw until all four screws are secure and tight against the
upper column. Do not overtighten.
Note: Refer to the C764 Addendum for assembly instructions regarding
the vertical handlebars.
Diagram 2 Install upper column onto
base frame assembly
Base frame assembly
Column support mount
Upper column
Screw
Split washers
Boot
Base frame mount