Owner`s manual

page 5
COMMERCIAL PRODUCTS DIVISION
d. Hold the electronic console display above the upper column support
while your assistant unwraps the ribbon cable and threads it through the
upper column support. Grab the connector at the base of the column and
gently pull it out. See Diagram 3. Do not connect the cables at this time.
CAUTION: Be sure not to crimp or pinch the ribbon cable as you
place the electronic console display into position. Cables pinched
or otherwise damaged by improper installation will not be covered
by the limited warranty.
Diagram 3
Thread ribbon cable
connector
Base frame assembly
Diagram 4
Attach electronic console
display to upper column
support
Electronic console
e. Take the three screws (C), three lock washers (D) and three washers (E)
from the hardware kit. Place the lock washers and then the washers on
the screws. Align the mounting holes on the electronic console display
with the upper column support and insert the screws so that the washers
are against the upper column support. See Diagram 4. Be sure that the
bottom of the display is parallel with the top of the upper handrail clamp.
Alternately tighten each screw using the appropriate Allen wrench until
all three screws are secure and tight against the mounting plate. Do not
overtighten.
Boot
Upper column support
Ribbon cable receptacle
Ribbon cable connector
Upper column support
Mounting plate
Screw
Washer
Lockwasher
Upper handrail clamp