Owner`s manual

page 6
COMMERCIAL PRODUCTS DIVISION
Diagram 5
5. Take the ribbon cable connector that you threaded through the upper
column support in step 4d. and open the tabs on the ribbon cable receptacle.
Plug the connector into the receptacle. See Diagram 5. Make sure that all
pins are aligned and the tabs are fully engaged. The connector is designed
to engage in one direction only. Do not force the connector into the
receptacle. Gently push the excess ribbon cable and connectors back up
into the upper column support.
Connect ribbon cables
correctly
Correct alignment
Incorrect alignment
Ribbon cable receptacle
Ribbon cable connector
Tab
6. Lower the rubber boot over the base frame casing and column support
mounts. Push down on the boot to secure it onto the base frame casing. See
Diagram 6. Make sure that the boot seats correctly over the cover extrusion.
Diagram 6
Slide boot into position
Upper column support
Base frame casing
Boot
Cover extrusion