Owner`s manual

page 7
COMMERCIAL PRODUCTS DIVISION
Diagram 7
Install lower handrails
Handrail boot
Wide portion of boot
Lower handrail
Locknut
Base mount
7. Take the following steps to secure the handrails onto the climber:
a. Take a handrail boot (J) from the hardware kit and slide it onto the base
of each handrail. Refer to Diagram 7. Be sure to mount the bell-shaped
boot properly. The wide portion of the “bell” should be facing toward the
base.
b. Place the lower portion of the handrails onto the base mounts.
c. Insert the upper-portion of the handrails into the handrail clamp on the
upper column support. Refer to Diagram 8. Push the handrails together
so that the handrails meet in the center of the clamp. The foam wrap on
both handrails should be snug up against the handrail clamp.
d. Return to the lower handrail mounts and insert the bolts (F) and attach
the locknuts (G), but do not tighten until the upper handrails have been
fully secured inside the upper handrail clamp.