Owner`s manual

page 11
COMMERCIAL PRODUCTS DIVISION
RESET: While you are answering the setup prompts, you can cancel the
program, clear the display, and return to the initial start-up prompt, by pressing
RESET. The initial start-up prompt, “PRESS ENTER FOR PROGRAMS OR
PRESS QUICK START” appears on the display. You can then begin another
exercise program. During a workout on the C764 climber, pressing RESET exits
the course or program, erases the workout statistics, and displays the start-up
prompt after the climber performs a systems diagnostic test. The foot pedals
return to a very slow fall rate during this time and do not change until you return
to a program or choose a new course.
WORK LEVEL/SPEED: The or keys change the “work level” by changing
the step rate which increases/decreases the degree of effort. You decrease the
step rate (causing the foot pedals to travel slower ) and increase the resistance
when you press the key. The opposite occurs when you press the key.
ENTER: When you turn ON the climber, several prompts appear before you
start your workout. Each prompt needs to be addressed and then “entered” into
the climber’s memory by pressing the ENTER key.
QUICK START: If you wish to use the manual program, you can bypass the
setup prompts by pressing the QUICK START key. When you begin working out,
the amount of time you have been on the climber and the number of floors
climbed appears on the electronic console display.
Note: The weight setting defaults to 150 pounds (70 kg) so all calorie calcula-
tions and their associated displays are based on a body weight of 150 pounds.
The time selection defaults to the club limit set in memory. You cannot change
the weight or time setting if you use the QUICK START option.
GRAPHIC DISPLAY ON THE C764 CLIMBER
The left window display on the C764 electronic console provides graphic
information about your workout session. The course profile that appears in the
left window display corresponds to the program you selected. As you proceed
through your workout, your position is indicated by a blinking cell.
WORK LEVEL: Shows the selected effort level, from 1 to 10. The higher the
number, the faster your step rate becomes. You can change the work level
anytime during a workout by using the WORK LEVEL/SPEED and keys to
increase or decrease the degree of effort in your workout.
Note: A WORK LEVEL indicator does not appear when you use the manual or
interval programs.