Owner`s manual

To assist you in the assembly, refer to Diagram 1 while per-
forming the steps below.
Tools needed: 5/32" and 3/16" Allen wrenches, crescent or
open-end wrench
1. Expose the ribbon cable connection. (Diagram 2) Slide
the rubber boot up the column to expose the ribbon cable
connection. Disconnect the connector from the receptacle.
Diagram 2
Disconnect ribbon cable.
Diagram 3
Remove display console.
2. Remove the display console. (Diagram 3) Use a 5/32"
Allen wrench to remove the 3 bolts that secure the console
to the upper column. Keep the washers on the bolts and set
them aside. Carefully, remove the ribbon cable from inside
the upper column. Do not crimp or stretch the ribbon cable.
Rubber boot
Ribbon cable
Display console
Bolt and washers
Ribbon cable
Handrail clamp