Owner`s manual

USA

Diagram 4

Remove the handrail clamp

and discard the nuts.

3. Remove the handrail clamp. (Diagram 4) Nylock

nuts

hold the 2 handrail clamp bolts to the upper column. Care-

fully place your hand inside the upper column to catch the

nuts as they become loose. Use an 3/16" Allen wrench to

loosen and remove the 2 bolts from the handrail clamp. Set

the bolts aside, but discard the nuts.

Diagram 5

Attach and secure vertical

handlebars.

4. Slide the vertical handlebars into position and align the

bolt holes. (Diagram 5) Open about a 2 inch gap between

the upper column and the handrail clamp by pulling or

pushing the handrails toward the foot pedals. Position the

vertical handlebar bracket between the upper column and

the handrail clamp. Align the mounting holes and replace

the 2 bolts. If necessary, have an assistant hold one side of

the vertical bars while you complete this step.

5. Use the Nylock

nuts provided to secure the vertical

bars and handrail clamp. Be sure to use 2 of the

new

Nylock

nuts supplied. Finger tighten the nuts while you hold

the bolts in position with the Allen wrench. Secure the nuts

using a open-end wrench (or crescent wrench). Hold the

nuts with the wrench and tighten the bolts with the 3/16"

Allen wrench.

Handrail clamp bolts

Upper column

Handrail clamp

Vertical handlebars

Vertical handlebar bracket

Handrail clamp

Upper column