Owner`s manual

6. Replace the display console. (Refer to Diagram 3) Once

the handrail clamp is secured, hold the display console

above the upper column and thread the ribbon cable down

through the column and out its base. Carefully lower the

display onto the upper column. Be sure not to crimp or

pinch the ribbon cable. Replace the 3 bolts and washers

and tighten them using a 5/32" Allen wrench.

Note: For those assembling the C764 unit, complete the

assembly process by continuing with steps 4d through 7d

in the

C764 Owner’s Manual

7. Reconnect the ribbon cable. Plug the connector into the

receptacle (refer to Diagram 2). Make sure that all pins are

aligned and fully engaged. Gently push the excess ribbon

cable and the connectors up into the column support.

8. Replace the rubber boot. Lower the rubber boot back into

place (refer to Diagram 2) over the base frame and upper

column support mounts. Make sure that the boot seats

correctly over the plastic casing.

You have completed the installation of the C764 vertical

handlebars. The vertical handlebars are for balance during a

workout. Excessive pulling or strain on the handlebars may

loosen the handrail clamp bolts. Occasionally check the

handrail clamp bolts and tighten them when necessary.

Precor is a registered trademark and

“C” is a trademark of Precor Incorporated.

P/N 38139-101

12/97

USA

Precor Incorporated

P.O. Box 3004

Bothell, WA USA 98041-3004