Service manual

C762, C764, C764i Stairclimber
Page 13
Procedure 2.3 - Selecting Club Settings
Procedure
1. Plug the power cord into the wall outlet, then turn on the climber with the ON/OFF switch.
2. Units manufactured after May 28, 2000 (software version 6.20) Utilize standard access
codes. See Diagrams 2.1 and 2.2 for key number assignments.
3. On units manufactured prior to May 29, 2000, at the PRESS ENTER FOR PROGRAMS
prompt, press and hold all three CHANGE keys simultaneously until the CHOOSEUNITS
[M/DN FT/UP] prompt is displayed.
4. On units manufactured after may 28, 2000, press keys RESET, 5,6,5,1,5,6,5, sequentially.
The C762 display is shown in Diagram 2.1 and the C764 display is shown in Diagram 2.2.
5. Press the WORK LEVEL ▲ key to select U. S. Standard units. Press the WORK LEVEL ▼
key to select the Metric measurement system.
6. When the MAX WORKOUT prompt is displayed, use the ▲ or ▼ keys to designate a
workout time limit between 10 and 240 minutes. Press ENTER when the desired time
appears. The MODIFY CUSTOM prompt displays.
7. If you plan to modify the custom course currently selected...
THEN... OTHERWISE...
Press the WORK LEVEL ▼ key; then Press the WORK LEVEL ▲ key; then
continue with the next step. skip to Step 7.
Note:
When the CHOOSE COURSE USE UP/DOWN OR PRESS ENTER prompt appears, either the
digit '1' or the digit '2' is displayed in the left LED matrix.
8. To change the custom course, press either the WORK LEVEL ▲ or WORK LEVEL ▼ key.
The digit in the left LED matrix will cycle from '1' to '2' or '2' to '1'.
Note:
Instructions for designing custom courses are provided in the C760 Series Climber Owner's
Manual.
9. Press the RESET key to return to the PRESS ENTER FOR PROGRAMS prompt.