Service manual

C762, C764, C764i Stairclimber
Page 40
Note:
Take care not to pinch the cables when you perform the next step.
10. Push the power entry module into the climber. Install the screws that secure the power entry
module to the climber frame.
11. Install the screws that secure the left cover to the climber frame.
12. Position the right cover against the climber frame; install the screws that secure the right
cover to the climber frame.
13. Tighten the fasteners that secure the top of the cover to the climber frame. Tighten both
screws if you removed both covers.
14. Position the front cover seal so that it overlaps the edges of both the right and left covers.
Press the strip firmly into place. Repeat this step for the rear cover seal.
15. Slide the collar down the column and over the column mounting screws. Press down to
ensure a snug fit.
16. Plug the power cord into the wall outlet, then turn on the climber with the circuit breaker.
17. Operate the climber 1–2 minutes. As you operate the climber, make sure that the stairarm
belts do not rub against the cover and that the cover bracket does not rub on the sheave.
Adjust the position of the stairarm belts or cover bracket if necessary.