Service manual

C762, C764, C764i Stairclimber
Page 45
Diagram 7.3 - Power Entry Wiring
Replacing the Power Cable Harness
7. Push the power cord into the round hole on the front of the power entry module. Make sure
that the power cord connectors can reach the ground stud and circuit breaker.
8. Place the strain relief around the power cable insulation that is next to the outside of the
power entry module.
9. Using the pliers, press the two sections of the strain relief together while you push the strain
relief into the round hole on the front of the power entry module.
10. Connect the in-line connectors on the ends of the loose blue wires attached to the input filter
assembly and the power cord (see Diagram 7.3).
11. Connect the brown wire on the power cord to the line terminal on the circuit breaker.
12. Position the power entry module near enough to the climber to connect the lower ribbon
cable to the lower PCA.