Service manual

C762, C764, C764i Stairclimber
Page 46
13. Connect the remote sensor cable and the magnet harness to the lower PCA.
14. Place the ground cable assembly and the ground wires attached to the input filter assembly
and power cord on the power entry module ground stud. Install the nut that secures the
wires on the ground stud.
Note:
Take care not to pinch the cables when you perform the next step.
15. Push the power entry module into the climber. Install the screws that secure the power entry
module to the climber frame.
16. Check the operation of the climber as described in Section Four, Checking Unit Operation.